Torque Spec for Dana 35 Carrier Bearing Caps Jeep Enthusiast Forums

Jeep 4 0 Main Cap Torque. Jeep 4.0 rear main seal thoughts Page 4 Jeep Wrangler TJ Forum Need torque specs foe a 2000 jeep with a 4.0 to be spacific i need the mains rods and head Hello mooredavid42, The Head bolt torque is as follows: 1 What I have found was 33lbs but the motor will not turn over even with using a 3ft cheater pipe

Come join the discussion about reviews, performance, trail riding, gear, suspension, tires, classifieds. Apply Loctite 515, or equivalent on rear bearing cap

Help with main bearing torque Diesel Place

4.0 Rear Main Seal Replacement - Replacing the rear main seal in your 4.0 inline 6 1998 Jeep Grand Cherokee 4.0 I6 laredo 470k 1990 Jeep Grand Wagoneer 158k 1976 Jeep J10. DO NOT strike the cap more than twice for proper engagement

I need to know the torque settings main bearing and big end bearing of. Tighten all bolt in the sequence shown in the image below to 22 ft The Main bearing cap where the rear main seal is on, and also the rod bearing cap what are the torque specs ?.

Help with main bearing torque Diesel Place. Apply Loctite 515, or equivalent on rear bearing cap I know the main bearing cap studs should be torqued to 80lbft but does anyone know what the girdle retaining nuts are supposed to be torqued to? This applies to '96+ 4.0 engines